\n| Stackup<\/td>\n | 12 copper layers — 6 signal, plus ground and power planes<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n Note what the bottom face is: 48 × 32 at 2.0 mm is exactly<\/em> an ordinary coarse-pitch BGA footprint. Whatever the die needed, the board below sees 2.0 mm pitch with 1.1 mm of clear space between pads — three traces per gap on a normal process.<\/p>\nWhy it is worth doing<\/h2>\nThe difficulty is bounded.<\/strong> An HDI substrate 94 × 62 mm is a small, cheap thing to build compared with a 256 × 112 mm main board on the same process. You buy the expensive process only where the density actually is.<\/p>\nIt is solved once.<\/strong> The escape is a self-contained geometry problem with no system context. Solve it, verify it, and it does not need solving again for the next revision, the next board, or the next product using the same silicon.<\/p>\nYour fabricator list stays long.<\/strong> The main board goes to anyone. Only the substrate needs a shop that quotes laser-drilled microvias and via-in-pad.<\/p>\nRails get cheap.<\/strong> Power and ground balls do not need an escape channel at all — they drop straight into a plane through their own via. On this interposer 576 of the 1,536 balls are rails, so only 960 ever compete for routing space. That is a large fraction of the problem that simply disappears.<\/p>\nWhat it costs you, honestly<\/h2>\nAn extra interface.<\/strong> Two solder joints per net instead of one. That is a yield and reliability consideration, and it is real.<\/p>\nZ-height and inductance.<\/strong> You have added a substrate to the stack. For most signalling that is nothing; for the tightest power delivery or the fastest edges it is a number you have to actually check rather than wave at.<\/p>\nIt is genuinely HDI.<\/strong> Laser-drilled microvias, blind vias, via-in-pad, and capture pads sized to the drill. Get a quote before you commit — it will not price like a two-week prototype, and a fabricator who says “sure, HDI” without asking about stacked versus staggered vias is not the one you want.<\/p>\nThe escape may not be complete.<\/strong> A fine-pitch fan-out is a hard routing problem and honest suppliers tell you the coverage figure rather than implying 100%. Ask for it. If nobody will give you a number, that is the number.<\/p>\nWhen you do not need one<\/h2>\nIf your part is already coarse — 1.8 or 2.0 mm pitch with generous pads — run the channel arithmetic and you will find you have three traces per gap and no problem to solve. An interposer there is pure added cost and an added interface. The tool is for the case where the arithmetic returns zero.<\/p>\n |